Petroleum Distillates: Why Are They Dangerous?
The hazard that matters most is aspiration: a mouthful that slips into the lungs can be fatal. Flammability, drowsiness and skin damage vary from one grade to the next, so the SDS for your exact product tells you more than the name on the label.
On this page
- What “petroleum distillates” means on an SDS
- The hazard they share: aspiration (H304)
- Why a non-flammable distillate still says Danger
- Flammability depends on the grade, and on how you use it
- Breathing the vapour and skin contact
- Do petroleum distillates cause cancer?
- There is no single UK exposure limit
- Why the consumer versions are packaged differently
- Using the SDS for your product
- Frequently Asked Questions
“Petroleum distillates” is not one chemical. It is a family name for liquids separated from crude oil by boiling range, running from light naphthas through white spirit and kerosene to heavier oils, and it appears on SDSs for spray lubricants, polishes, lamp fuels, degreasers and paints. What most of the thinner grades have in common is a hazard that has little to do with how poisonous the liquid is to drink, and a lot to do with where it goes when someone swallows it.
What “petroleum distillates” means on an SDS
Each fraction is a mixture rather than a single compound. UKHSA describes kerosene, for example, as a mixture of C9 to C16 hydrocarbons produced by distilling crude oil, and its exact make-up depends on the crude and the processing.
Regulators deal with this by treating each fraction as a separate substance with its own identifier. Hydrodesulphurised kerosine is CAS 64742-81-0, for example, while the US NIOSH Pocket Guide lists “petroleum distillates (naphtha)” under CAS 8002-05-9. Newer UK SDSs often use a descriptive name instead, such as “Hydrocarbons, C11–C14, n-alkanes, isoalkanes, cyclics, <2% aromatics” with an EC number.
The practical point: when an SDS says petroleum distillates, go to Section 3 and find the specific CAS or EC number, because the hazards differ from one member of the family to the next. White spirit is one of them, and we cover it on its own in White Spirit: Why Is It Dangerous?.
The hazard they share: aspiration (H304)
Aspiration means a liquid entering the windpipe and lower airways, either straight from the mouth or nose or indirectly through vomiting. The result can be severe chemical pneumonia. For kerosene, UKHSA names chemical pneumonitis, typically from breathing in vomit, as the main hazard.
GB CLP’s classification criteria turn this into a simple test. A hydrocarbon with a kinematic viscosity of 20.5 mm²/s or less at 40°C is classified in Aspiration Hazard Category 1, which carries the signal word Danger and the statement H304, “May be fatal if swallowed and enters airways”. Most solvent and fuel grades of petroleum distillate fall under that cut-off. A mixture whose Category 1 ingredients add up to 10% or more, with the same low viscosity, is classified Category 1 as a whole, which is how a polish or lubricant ends up carrying H304 even when the distillate is only part of the recipe.
The first-aid advice follows from the mechanism. If someone may have swallowed a distillate, NHS guidance is to call 999 or go to A&E, not to make them sick, and not to give them anything to eat or drink. Vomiting gives the liquid a second chance to reach the lungs. Take the container or the SDS with you.
Aerosols are assessed slightly differently. The deciding question under CLP is whether the product can form a pool in the mouth, so a fine mist from a pressurised can is treated differently from a stream or a coarse trigger spray. Check the SDS for the format you actually buy rather than assuming the aerosol and the bulk tin match.
Why a non-flammable distillate still says Danger
Two real UK SDSs show how far the classifications can spread. A typical kerosene SDS lists five hazard classes: flammable liquid Category 3 (H226), skin irritation (H315), drowsiness or dizziness (H336), aspiration Category 1 (H304) and long-term aquatic toxicity (H411). Only the aspiration hazard is mandatory for kerosene in GB; the other four are the supplier’s own classification. A dearomatised C11–C14 hydrocarbon solvent classified under GB CLP lists only one: H304. Its flash point is above 64°C, so it is not classified as flammable at all.
Both carry Danger. Aspiration Category 1 is a Danger-tier class on its own, and under CLP’s precedence rule one Danger-tier class sets the signal word for the whole label, the same mechanism explained in Danger vs Warning on chemical labels. So the absence of a flame pictogram tells you nothing about whether a distillate is safe to swallow, siphon or decant into an unmarked container.
Flammability depends on the grade, and on how you use it
CLP sorts flammable liquids by flash point and boiling point. A flash point below 23°C puts a liquid in Category 1 or 2 (H224 or H225), and a flash point from 23°C to 60°C puts it in Category 3 (H226). The lightest, most volatile grades such as low-boiling naphthas can reach Category 1 or 2, while kerosene usually lands in Category 3. For comparison, the isopropyl alcohol covered earlier in this series is Category 2.
A flash point above 60°C does not end the fire risk. HSE’s tank storage guidance points out that higher-flash-point liquids can still produce a flammable atmosphere when they are heated, or released under pressure as a mist or spray, and DSEAR covers high-flash-point liquids used at elevated temperatures even where CLP does not class them as flammable. A leaking pressurised line or a heated parts-washer needs assessing on those terms, not on the label alone.
Use the classification in Section 2 and the flash point in Section 9 of the SDS for the product you hold, rather than borrowing values from another fuel or solvent. Our chemical storage checklist covers how to separate flammables from incompatible materials.
Breathing the vapour and skin contact
The lighter, more volatile grades give off enough vapour to affect the central nervous system, which is what H336 on the kerosene SDS refers to. HSE lists headaches, nausea, dizziness and impaired co-ordination among the effects of solvent vapour, and warns that high concentrations can cause unconsciousness and even death. Spraying, heating and enclosed spaces push exposure well above what wiping in a ventilated room produces, which is why HSE advises avoiding spraying where possible. A particulate filter does not protect against solvent vapour, so a dust mask is not a fallback.
On the skin, these liquids strip natural oils. UKHSA identifies dermatitis as the most common health effect of long-term kerosene exposure, and HSE links repeated solvent contact to dermatitis more generally. HSE also advises never using solvents to clean paint or grease off your skin. Glove choice should come from Section 8 of the SDS, because not every glove material resists hydrocarbon solvents.
Do petroleum distillates cause cancer?
Some can, and the answer depends on what is left in them after refining. Most of the petroleum substances on HSE’s GB mandatory classification list carry a mandatory carcinogen classification, and naphthas also carry a mutagen classification. Many of those entries come with a note that sets a condition. Under Note P, the carcinogen or mutagen classification applies unless the supplier can show the substance contains less than 0.1% w/w benzene; if it can, the supplier must classify those hazards again under the normal CLP rules. Note L works the same way for certain oils, using a DMSO extract below 3% by the IP 346 test.
In practice, two SDSs that both describe their contents as petroleum distillates can disagree on cancer hazard and both be correct. A naphtha with 0.1% or more benzene keeps its Carcinogen 1B (H350) and Mutagen 1B (H340) classification; the dearomatised C11–C14 grade mentioned above carries no such classification. Check Section 2 for H350 or H340, and Section 11 for the reasoning.
There is no single UK exposure limit
EH40/2005, the list of UK workplace exposure limits, has no Table 1 entry for kerosene, naphtha, mineral oil or petroleum distillates. Instead, it sets out a reciprocal calculation procedure that suppliers use to work out an in-house limit for a hydrocarbon solvent from its composition. That procedure covers vapours only, not mists, and the group guidance values it uses have no legal status, so an in-house figure on an SDS is not a statutory WEL. This is why SDSs for similar products quote different figures, or none.
Imported SDSs sometimes quote US numbers instead: a NIOSH recommended limit of 350 mg/m³ or an OSHA limit of 500 ppm for petroleum distillates (naphtha). Those are US limits, not UK WELs. With or without a WEL, COSHH regulation 7 still requires exposure to be prevented or, where that is not reasonably practicable, adequately controlled.
Why the consumer versions are packaged differently
Because swallowing is the main route to serious harm, products sold to the public carry extra packaging rules. Under GB CLP Annex II, anything classified for aspiration hazard needs a child-resistant fastening in any pack size and a tactile warning of danger, unless it is sold as an aerosol or in a container with a sealed spray attachment. Under UK REACH Annex XVII, entry 3, H304 lamp oil and barbecue lighter fluid for the public must come in black, opaque containers of one litre or less, with a prescribed warning that a single sip, or sucking a lamp wick, can cause life-threatening lung damage.
None of those protections survive decanting. A distillate poured into an unlabelled container or an old drinks bottle at work loses its closure, its warning and its signal word in one step.
Using the SDS for your product
HSE is clear that an SDS is not a risk assessment: it is the supplier’s information that feeds into yours. For a petroleum distillate, these are the sections that matter most:
- Section 3: identify the actual substance by CAS or EC number, not by the family name.
- Section 2: read every hazard class. Aspiration, flammability and any carcinogen or mutagen classification can all be present at once.
- Section 4: confirm the first-aid advice for swallowing, which should say not to induce vomiting.
- Sections 8 and 9: note any in-house exposure limit, the recommended glove material and the flash point. Our guide to Section 8 explains how to read the controls.
Bring those details into your COSHH risk assessment alongside how the product is actually used: who handles it, how often, whether it is sprayed or heated, and where. If any section is missing or the document predates GB CLP, ask the supplier for the current version; our overview of the 16 SDS sections explains what each one should contain.
Frequently Asked Questions
Are all petroleum distillates dangerous?
Most thin grades, including kerosene, naphthas and white spirit, are classified as aspiration hazards and carry Danger. Their other hazards differ, so check Sections 2 and 3 of the SDS for the specific product.
Why does my product say Danger when it isn't flammable?
Most thin petroleum distillates are classified Aspiration Hazard Category 1 (H304), which carries Danger on its own. Under CLP’s precedence rule that sets the signal word, whatever the flammability.
What should I do if someone swallows a petroleum distillate?
Call 999 or go to A&E. Do not make them vomit, as vomiting can carry the liquid into the lungs, and do not give them anything to eat or drink. Take the container or SDS with you.
Is there a UK workplace exposure limit for petroleum distillates?
There is no single EH40 entry. Suppliers calculate an in-house limit for hydrocarbon solvent vapours using HSE’s reciprocal calculation procedure, so check Section 8 of your SDS.
Do petroleum distillates cause cancer?
Many petroleum substances carry a mandatory carcinogen classification because of constituents such as benzene. Under Note P a supplier can reassess it if benzene is below 0.1%, so the answer differs from grade to grade. Check Section 2 for H350.
You Might Also Find Useful
Free SDS and Chemical Risk Assessments
Search more than 1.5 million Safety Data Sheets and linked Chemical Risk Assessments.
- ✓ Search by substance, product, or manufacturer
- ✓ Save documents to your library
- ✓ Register free in under two minutes
